DPA 5015A

Directional pattern: wide cardioid
Principle of operation: pressure gradient
Cartridge type: pre-polarized condenser
Frequency range: 20Hz to 20kHz
Frequency range, +/-2dB: 40Hz to 20kHz
Sensitivity, nominal, +/-2dB at 1kHz: 10mV/Pa, -40dB re. 1V/Pa
Equivalent noise level, A-weighted: typ. 18dB(A) re. 20uPa (max. 20dB(A))
Equivalent noise level, ITU-R BS.468-4: typ. 25dB (correct with the attenuator in 0dB or -20dB setting)
S/N ratio (A-weighted), re. 1kHz at 1Pa (94dB SPL): typ. 76dB(A)
Total harmonic distortion (THD): <1% up to 139dB SPL peak
Dynamic range: typ. 121dB
Max. SPL, peak before clipping: 159dB
Switchable attenuator, filters etc.: 0dB / -20dB
Output impedance: 200Ohm
Minimum load impedance: 2kOhm
Cable drive capability: 100m
Output balance principle: Impedance balancing with Active Drive
Common mode rejection ratio (CMRR): >60dB
Power supply (for full performance): 48V Phantom power (+/-4V)
Current consumption: 2.8mA
Connector: XLR-3M. pin 1: shield, pin 2: signal + phase, pin 3: phase
Color: matte black
Weight: 158g
Microphone/capsule diameter: 19/19mm
Microphone length: 170mm
Maximum output voltage, RMS: >5V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40°C to 45°C
Relative humidity (RH): up to 90%
Matching tolerance (frequency response and sensitivity): +/-1dB
Phase deviation for kit: <10°