Lectrosonics DCHT

Description

Lectrosonics DCHT 2 Channel Digital Camera Hop Transmitter

Lectrosonics DCHT 2 Channel Digital Camera Hop Transmitter is designed for use in film and television production to provide a wireless link from a bag or cart system to cameras and recorders. The transmitter will accept mic or line level analog signals or AES digital signals from a mixer and transmit the signals to the receiver in a pure digital format.

Tunes across entire UHF frequency range – 470-614MHz
• TA6F Input – 2 Channels
• Selectable RF power at 10, 25 and 50 mW

The DCHT is compatible with the Lectrosonics M2R receiver. The digital architecture is a third generation design with specially developed, high efficiency digital circuitry for extended operating time on two AA batteries.

Features:

Compatible with Duet M2R receiver

Tunes across entire UHF frequency range

TA6F top input connector

256-bit encryption – AES 256-CTR

Selectable RF power at 10, 25 and 50 mW

AES and analog mic and line level inputs

USB port for firmware updates

Wide range input gain adjustment

DSP-controlled input limiter

Two AA battery power

Solid machined aluminium housing

Optional powering from external DC

The transmitter can tune in coarse or fine steps across the UHF television band from 470.100 to 607.950 MHz, with a selectable output power of 10, 25 or 50 mW. The pure digital architecture enables AES 256-CTR encryption for high level security applications.

Studio quality, stereo audio performance is assured by high quality components in the preamp, wide range input gain adjustment and DSP-controlled limiting. Input connections and settings are included for any lavaliere microphone, dynamic microphones and line level inputs. Input gain is adjustable over a 51 dB range in 1 dB steps to allow an exact match to the input signal level, maximising the dynamic range and signal to noise ratio.

The top panel contains the antenna jack, two audio input level LEDs (one per audio channel), the programmable function switch and the audio input jack. The red/green LEDs provide audio level indications from -20 dB to the onset of limiting for each channel for accurate input gain adjustment. The programmable switch can be congured as a mute switch, a power on/off switch, or be bypassed.

The 6-pin input jack accepts two mic or line level analog signals or AES digital signals from external sources via a variety of adapter cables. Analog inputs can be linked for the same gain when used with a stereo source, or operate independently with individual settings. The housing is constructed of solid machined aluminium for lasting ruggedness. The exterior is finished with an ultra hard, dark electroless nickel finish.

The 6-pin input jack accepts two mic or line level analog signals or AES digital signals from external sources via a variety of adapter cables. Analog inputs can be linked for the same gain when used with a stereo source, or operate independently with individual settings.

The housing is constructed of solid machined aluminium for lasting ruggedness. The exterior is finished with an ultra hard, dark electroless nickel finish.

The transmitter is supplied with a stainless, spring wire belt clip that is secure, but easily detached and re-attached without tools. A spring-loaded belt clip is available as an option. The battery door is machined aluminium, hinged to the housing to prevent it being lost. The battery door latches securely to prevent being opened inadvertently, and will not pop open even if the unit is dropped.

Firmware updates are made via the USB port on the side panel of the housing. The procedure is very simple using a menu item on the transmitter and a standard micro USB cable.

Setup and adjustment is enabled through a backlit LCD, membrane switches and an intuitive menu structure. Input gain is adjustable over a wide range in 1 dB steps to optimize modulation and limiting for maximum signal to noise ratio and minimum distortion.